Chemistry lab report Essay

* PurposeFinding the function of urine molecules tie to sloven sulfate crystals CuSO4.x body of urine system.* To avoid error1. Do not dispatch too much movement around the equilibrise when taking whatever sens.2. Wait till the balances reading is stable past take the reading.3. Make sure that the crystals are well distributed in the beaker to be evenly exposed to as much heat as possible.* In case the experiment was repeated for more accuracy in the net results, variables should be controlled1. Use the same balance.2. Use same size and charm of the container (Beaker or evaporating dish)3. Use exactly the same sess of copper sulphate crystals.4. Apply the same amount of heat at the same meter intervals.5. Control room temperature.* Apparatus1. Beaker.2. Balance.3. Watching field glass.4. Glass stirring rod.5. heated up scale leaf.6. Tongs.7. Goggles.* Procedure1. The mass of the empty beaker is measured using the balance and put together to be 29.92g2. The mass of the honoring glass is measured using the balance and found to be 58.95g3. The copper sulphate, which is a light blue powder, is be make added to the beaker and the total mass of the beaker and the copper sulphate is 33.86g4. Wear the goggles for safety.5. papal bull sulphate is heated using the hot plate, the color of the powder in stages changes from light blue to white starting from the bottom of the beaker up and water vapor provoke be seen on the beakers walls.6. The powder becomes a little clumpy during heating.7. The beaker is shaken and the powder is stirred using the stirring glass rod every instantaneously and then to expose the upper split of the powder to more heat and allow them to dehydrate properly.8. As shortly as the entire powder turns white, the beaker is covered with watching glass to forestall copper sulphate from reacting, again, with water vapor in the atmosphere. Also, the hot plate is now turned off.9. The mass of the dehydrated copper sulphate on w ith that of the beaker and the watching glass is now taken and found to be 91.60g.* treat1. By subtracting the mass of the empty beaker measured at the beginning of the effect from its mass along with the copper sulphate, the mass of hydrated copper sulphate used at the beginning is found.33.86g 29.92g = 3.94g2. By subtracting the mass of the empty beaker and watching glass measured at the beginning of the procedure from the final mass of the procedure, the mass of dehydrated copper sulphate is obtained.91.60g (58.95g + 29.92g) = 2.73g3. The mass of evaporated water molecules can now be found by subtracting the mass of dehydrated copper sulphate from the mass of hydrated copper sulphate.3.94g 2.73g = 1.21g4. The bit of moles of evaporated water is now calculated by the ruleNumber of moles = Mass / Molar massWhere the molar mass of water is 18 g/moln = 1.21g / 18g.mol-1= 0.067 mol5. The number of water molecules is now calculated by multiplying the number of moles times Avogadr os number (6.02*1023)Number of molecules = n*NA= 0.067*6.02*1023=4.03*1022 molecules6. The symmetry is calculated to find the number of molecules attached and the formula of the compoundCuSO4H2OMass (g)2.731.21Molar mass (g/mol)15918Number of moles (mol)0.1720.067Ratio1100.393.9 4* ConclusionThe aim of this was to determine the number of water molecules attached to copper sulphate and that is a 4.03*1022 molecule where the compound has a formula of 10CuSo4.4H2O* Sources of error1. Uncertainty of the balance used.2. Stirring may cause crystals to stick on the stirring glass rod affecting the mass.3. The beaker has a small surface area, therefore not all particles will be exposed to enough heat and so not all water molecules will evaporate.* Ways of improvingUse a container with a big surface area such as an evaporating dish to avoid the film of stirring and therefore copper sulphate crystals wont be lost by sticking to the glass rod. Also, this will increase the number of water m olecules exposed to heat and so it will increase the peril of dehydrating all of the copper sulphate crystals.